Mole-Mass Relationships Lab

Purpose of Lab

The purpose of this lab was to educate students on mass-mass relationships. Students can learn more on how these relationships occur in chemical reactions and in balanced chemical equations. 


Lab Manual Questions 




Our Product After Evaporation



Possible Error

Sources of possible error in our percent yield include how our substance had too much acid evaporation, which may have caused changes to our actual yield. Also, when we were adding the acid to the NaHCO3 with a dropper, we dropped the acid a little quicker than we should have, contrary to how the instructions tell us to gradually drop the acid in.



Comments

Post a Comment

Popular posts from this blog

Solid Evidence Lab

Image
The purpose of this lab was to investigate chemical reactions that cause solids to form. Our wellplate of the reactions  Net Ionic Equations What surprised me the most was how quickly the precipitate formed, especially in reaction 6 with NaOH and Cu(NO_3)_2. 
Read more

Flame Test Lab

Image
Summary In this lab, students were given many different substances to hold over a flame and were asked to observe the colors of the flame produced. This helped demonstrate the relationships of the flame colors and the certain atoms contained in compounds. Pre-lab Questions 1) What is the difference between ground state and an excited state?  Ground state is the most stable state where all the electrons are in the lowest energy levels. On the other hand, an excited state is where the electrons are in an unstable arrangement, and will go back to their normal positions of lower energy. 2) What does the word "emit" mean? The word "emit" means to "produce and discharge", especially in gas or radiation. 3) In this experiment, where are the atoms getting their excess energy from? In this experiment, the atoms are getting their excess energy from the heat of the bunson burner's flame, where the electrons can reach an excited state. 4) Why do
Read more

Solubility: A Guided Inquiry Lab

Image
Introduction The purpose of the lab was for students to, using a given graph of solubility, decipher whether an unknown substance is NaCl, NaNO2, or KNO3. Students were not given a procedure, so they had to design their own. Materials included beakers, a hot plate, a balance, a thermometer, a graduated cylinder, and a stirring rod.  Solubility- ability for a solute to dissolve in a solvent Solubility Curve- a graph of the variation of changing temperature of the solubility of a given substance in a given solvent Solute- smaller component of a solution that is dissolved into a solvent Solvent- larger component of a solution that dissolves the solute Solution- liquid mixture where the solute is evenly dispersed in the solvent Saturated Solution- solution containing the maximum concentration of a solute dissolved in the solvent Our Set-Up Procedure 1) We first obtained materials: beakers, a hot plate, a balance, a thermometer, a graduated cylinder, and a
Read more